Application Deployment
191
8. Touch OK.
9. Connect the device to the host computer using the Rugged Charge/USB Cable.
The Allow USB debugging? dialog box appears on the device.
10. On the device, touch OK.
11. On the host computer, navigate to the platform-tools folder.
12. Type adb devices.
The following displays:
List of devices attached
XXXXXXXXXXXXXXX device
(where XXXXXXXXXXXXXXX is the device number).
13. Touch .
Application Installation
After an application is developed, install the application onto the device using one of the following methods:
• USB connection, see Installing Applications Using the USB Connection on page 191.
• Android Debug Bridge, see Installing Applications Using the Android Debug Bridge on page 193.
• microSD Card, see Installing Applications Using a microSD Card on page 194
• Mobile device management (MDM) platforms that have application provisioning. Refer to the MDM
software documentation for details.
Installing Applications Using the USB Connection
1. Connect the device to a host computer using the Rugged Charge/USB cable.
2. Pull down the Notification panel and touch USB for Charging.
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
CAUTION:When connecting the device to a host computer and mounting its microSD card, follow the host
computer’s instructions for connecting and disconnecting USB devices, to avoid damaging or
corrupting files.
To Next Page
Loading...
Need help?
General
