Zebra MC33 Series - Replacement Hand Strap for MC33 XX-G

Accessories
82
Replacement Hand Strap for MC33XX-G
To install the hand strap:
1. Thread the lanyard loop through the opening near the base of the trigger handle.
Figure 61 Insert Loop Through Handle Slot
2. Insert the top end of the hand strap through the loop.
Figure 62 Thread Hand Strap Through Loop
3. Thread the hand strap through the lanyard.
4. Pull the hand strap through the loop.
5. Thread the end of the hand strap with the tab through the slot on the bottom of the MC33XX-G.