Zebra MC33 Series Integrator Guide

Accessories
68
MC33XX-S Rubber Boot
The rubber boot provides additional protection to the MC33XX-S.
To attach the rubber boot:
1. Slide the bottom of the MC33XX-S into the bottom of the rubber boot.
Figure 41 Attach Bottom of Rubber Boot
2. Grasp the top of the rubber boot and place over the top of the MC33XX-S.
Figure 42 Attach Top of Rubber Boot
NOTE: To function properly, remove the lower part of the rubber boot or the entire rubber boot before placing in
a charging cradle.

Zebra MC33 Series Specifications

General

Connectivity	USB 2.0, Bluetooth
Touch Panel	Capacitive, glove and wet touch support
Keypad Options	Touchscreen or physical keypad
Scanning	1D/2D barcode scanning
Wireless LAN	IEEE 802.11 a/b/g/n/ac
Operating Temperature	-20° C to 50° C