Zebra ZXP Series 3 - Page 57

2: Installation and Setup
Changing the Printer Driver Options
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 51
- Printing Mode - Sets the type of printing required:
• Print.
• Encode Only (use this when magnetic encoding is the only function desired,
printing will not occur).
• Print and Encode on same side prints on the magnetic stripe side of the card.
- Copies - Sets the number of copies of cards printed.
- Auto detect start of image for half panel ribbons - Enabled only when a half-panel
ribbon is installed. Automatically detects the edge of the color image to be printed;
see Appendix G for setting the edge manually.
• Single Feed options (refer to Appendix D for details on the single-card feed mode)
- Card feeder: The printer will attempt to a pull a card from the Card Feeder. If the
Card Feeder is empty, the printer will generate an
OUT OF CARDS error message.
- Single feeder slot: For each print job, the printer will generate an
INSERT CARD
message. Any cards in the Card Feeder will not be used.
- Auto feed: The printer will attempt to feed cards from Card Feeder first. If Card
Feeder is empty, the printer will generate an
INSERT CARD message. No OUT OF
CARDS
error message will be generated.
• Ribbon info and options
- Ribbon type displays the type of ribbon installed in the printer. Tagged ribbons
(e.g., YMCKO) are detected and displayed automatically. Untagged ribbons (Black
Monochrome and White Monochrome) must be selected from the dropdown menu.
Note that the type of monochrome ribbon selected is critical -- white monochrome
ribbon will not print acceptably with Black Monochrome selected.
- Ribbon combination is based on ribbon type; for example:
YMCKOK
• Front YMCKO, Back K.
• Front YMC, Back KO.
• Front YMCKO, Back YMCKO.
Depending on the printer model and ribbon combination selected, the Black Panel
Options and Overlay Varnish Options buttons are enabled; see Black (K) Panel on
page 52 and Overlay Varnish Options on page 58 respectively.
.