Aeroflex 3901 - Page 119

AutoTest Sytem Operation
Subject to Export Control, see Cover Page for details.
5-23
Config Commands (cont)
set_amfmdemod_fmdev_llen [ state 0/1 ]
Enables/Disables the lower limit check on fm deviation meter with peak deviation type.
Valid states are:
0 = Disabled
1 = Enabled
set_amfmdemod_am_average
Sets number of averages used to calculate measurement.
Format: Whole numbers
set_amfmdemod_amdepth_ulimit [ limit % ]
Sets upper limit on am depth meter.
Format: Decimal limit value as a percent
set_amfmdemod_amdepth_ulen [ state 0/1 ]
Enables/Disables the upper limit check on am depth meter.
Valid states are:
0 = Disabled
1 = Enabled
set_amfmdemod_amdepth_llimit [ limit % ]
Sets lower limit on am depth meter.
Format: Decimal limit value as a percent
set_amfmdemod_amdepth_llen [ state 0/1 ]
Enables/Disables the lower limit check on am depth meter.
Valid states are:
0 = Disabled
1 = Enabled
set_amfmmod_distortion_average
Sets number of averages used to calculate measurement.
Format: Whole number
Range: 1 to 250
set_amfmmod_distortion_ulimit [ limit % ]
Sets upper limit on mod distortion meter.
Format: Decimal limit value as a percent
set_amfmmod_distortion_ulen [ state 0/1 ]
Enables/Disables the upper limit check on mod distortion meter.
Valid states are:
0 = Disabled
1 = Enabled
set_amfmmod_sinad_average
Sets number of averages used to calculate measurement.
Format: Whole number
Range: 1 to 250\