Aeroflex 3901 - Page 118

AutoTest Sytem Operation
Subject to Export Control, see Cover Page for details.
5-22
Set Commands (cont)
set_amfmdemod_freq_llen [ state 0/1 ]
Enables/Disables lower limit check on demod frequency measurements.
Valid states are:
0 = Disabled
1 = Enabled
Config Commands
set_amfmdemod_freq_average
Sets number of averages used to calculate measurement.
Format: Whole numbers
Range: 1 to 250
set_amfmdemod_fm_average
Sets number of averages used to calculate measurement.
Format: Whole numbers
Range: 1 to 250
set_amfmdemod_fmrms_ulimit [ limit kHz ]
Sets upper limit on fm deviation meter with rms deviation type.
Format: Decimal limit value in kHz
set_amfmdemod_fmrms_ulen [ state 0/1 ]
Enables/Disables the upper limit check on fm deviation meter with rms deviation type.
Valid states are:
0 = Disabled
1 = Enabled
set_amfmdemod_fmrms_llimit [ limit kHz ]
Sets lower limit on fm deviation meter with rms deviation type.
Format: Decimal limit value in kHz
set_amfmdemod_fmrms_llen [ state 0/1 ]
Enables/Disables the lower limit check on fm deviation meter with rms deviation type.
Valid states are:
0 = Disabled
1 = Enabled
set_amfmdemod_fmdev_ulimit [ limit kHz ]
Sets upper limit on fm deviation meter with peak deviation type.
Format: Decimal limit value in kHz
set_amfmdemod_fmdev_ulen [ state 0/1 ]
Enables/Disables the upper limit check on fm deviation meter with peak deviation type.
Valid states are:
0 = Disabled
1 = Enabled
set_amfmdemod_fmdev_llimit [ limit kHz ]
Sets lower limit on fm deviation meter with peak deviation type.
Format: Decimal limit value in kHz