Aeroflex 3901 - Page 122

AutoTest Sytem Operation
Subject to Export Control, see Cover Page for details.
5-26
Set Commands (cont)
set_analyzer_rbwauto [ state 0/1 ]
Sets resolution bandwidth setting.
Valid states are:
0 = Manual
1 = Auto
set_analyzer_vbwauto [ state 0/1 ]
Sets video bandwidth setting.
Valid states are:
0 = Manual
1 = Auto
set_analyzer_sweepauto [ state 0/1 ]
Sets sweep setting.
Valid states are:
0 = Manual
1 = Auto
set_analyzer_peakenable [ state 0/1 ]
Enables/Disables peak trace measurement.
Valid states are:
0 = Disabled
1 = Enabled
set_analyzer_avgenable [ state 0/1 ]
Enables/Disables average trace measurement.
Valid states are:
0 = Disabled
1 = Enabled
set_analyzer_avgsize
Sets number of averages used to calculate measurement.
Format: Whole number
Range: 1 to 250
set_analyzer_trigger [ state 0/1 ]
Enables/Disables sweep trigger.
Valid states are:
0 = Disabled
1 = Enabled
set_analyzer_sweepsingle [ state 0 ]
Sets sweep mode to Single.
0 = Single
set_analyzer_sweepcont [ state 0 ]
Sets sweep mode to Continuous.
Valid states are:
0 = Single