General Power Meter Functions 2
N1911A/1912A P-Series Power Meters User’s Guide 83
Example of SCPI commands set
Refer to the following SCPI commands set for normal mode and average
mode in frequency sweep measurement.
Normal mode
This feature is applicable for E9320 and N1920 Series power sensor when
connected. Below are examples of SCPI commands when used in normal
mode. Send the SCPI commands below to meter using remote interface.
• SENS:DET:FUNC NORM
• TRIG:SOUR EXT
• SENS:FREQ:START 50 MHz
• SENS:FREQ:STOP 4 GHz
• SENS:FREQ:STEP 2048
Optional measurement configurations:
• TRIG:DEL 1ms
• TRIG:HOLD 10us
• OUTP:TRIG ON
• SENS:SWE1:OFFS:TIME 100us
• SENS:SWE1:TIME 100us
• INIT:CONT ON
• *OPC
• *ESR?
• FETC?
Refer to the P-Series Power Meters Programming Guide for the commands usage details.
To Next Page
Loading...
