Power Supply
The VCore includes an external universal power supply that allows connection too many domestic
as well as international wall voltages (110VAC, 220VAC, 200VAC) without special
configuration. The VCore uses a 2-position terminal block plug (3.5mm spacing) as its power
input.
The DC power requirements are 9-36 VDC at 1 Amp.
The power supply that comes with the VCore has the following specifications:
Input: 100-250VAC, 50-60Hz, 0.7-0.3A
Output: 18 VDC @ 3.3 Amps
Power over Ethernet
The VCore can also be powered via PoE(Power over Ethernet) class 3 (up to 13W),
which is a standard that passes both power and data along the same Ethernet cable. This
permits the installer to not have to wire the DC Power cable, if the network and wiring in
place supports the standard.
Rear DIP Switches
DHCP
The first switch is used to toggle DHCP. Down (ON) will enable
DHCP. Up (OFF) will disable this feature.
Contact Closure / Voltage Input
The second switch configures the VCore to receive either Contact
Closure or Voltage Input. Down (ON) will configure for Contact
Closure. Up (OFF) will configure for Voltage Input.
To Next Page
Loading...