LTC/SMPTE
Mode . . . SMPTE Time Display
Generate/Read shows the current mode of the SMPTE processor. The Display shows
the active time code clock.
Current Frame Time . . . SMPTE Status
The frame per second setting is displayed in this location. Status Idle/Running.
Stop, Start SMPTE:
This is the control for the SMPTE processor.
LTC/SMPTE Config:
This field will open the SMPTE configuration menu and the user can view the setting
such as the mode, frame rate, (preroll, start and end times), (loop, powerup, restart and
idle modes), and output levels.
Exit
Network
There are two independent network controllers in the V16Pro and each of them has
separate configuration options as follows
Network Adapter A (Defaults)
IP Address: 192.168.000.254
Subnet Mask: 255.255.255.000
Gateway: 192.168.000.001
Network Adapter B (Defaults)
IP Address: 192.168.000.253
Subnet Mask: 255.255.255.000
Gateway: 192.168.000.001
Exit
Password
Enter Password
Script Configuration
Script Filename is displayed in the first field. A directory of all the files found on the
CF card may be displayed by turning the menu-wheel. Pressing the menu-wheel will
select the file and cause it to begin flashing; pressing the wheel again will select that
script to be loaded at the next restart.
Reload will start the default script selected from the field above.
The View Watches permits the monitoring of script variables. The user may select a
number of variables to watch while the script is running. Selecting View Watches and
pressing the menu-wheel will display the watch list.
To Next Page
Loading...