Alcorn Mcbride V16Pro - IS; CT; ID

Serial and Ethernet Control Page 153
Control
IS Pause SMPTE (Immediately)
Description: This command will pause the SMPTE clock immediately.
Comments: When paused, the SMPTE clock can be resumed by sending an Enable SMPTE
command.
Get command: IS<0D>
Message Response: R<0D>
Example: Send Command: IS<0D>
Response: R<0D>
CT Get/Set SMPTE Time
Description: This command will get or set the current SMPTE time. If the parameter is
excluded the command is executed as a get command.
Comments: hh = hours mm = minutes
ss = seconds ff = frames
For now, this function must use two digits in each field even if it is zero(0) and
the delimiters between each field must be followed. hh:mm:ss.ff
Get command: CT<0D>
Message Response: hh:mm:ss.ff<0D>
Example: Send Command: CT<0D>
Response: 00:01:59.29<0D>
Set command: hh:mm:ss.ff CT<0D>
Message Response: R<0D>
Example: Send Command: 00:01:59.29CT<0D>
Response: R<0D>
ID Get/Set Unit ID
Description: This command will get or set the unit ID number.
Comments: The ID is used to identify the unit in a shared serial multi-drop line
configuration. Where xx is the unit ID in the range 0-49.
Get command: ID<0D>
Message Response: (0-49)<0D>
Example: Send Command: ID<0D>
Response: 0<0D>
Set command: (0-49)ID<0D>
Message Response: R<0D>