Alcorn Mcbride V16Pro - NJ; TS; SF

Serial and Ethernet Control Page 162
Message Response: R<0D>
Example: Send Command: 1NE<0D>
Response: R<0D>
NJ Get/Set the Ethernet Port for NTP
Description: This command will get or set the show controller Ethernet port used to contact
the NTP server.
Comments: A = port A, B = port B. The default port is A
Get command: NJ<0D>
Message Response: (current port)<0D>
Example: Send Command: NJ<0D>
Response: A<0D>
Set command: (port A or B)NJ<0D>
Message Response: R<0D>
Example: Send Command: ANJ<0D>
Response: R<0D>
TS Time Stamp
Description: This command will attach the time to the active script.
Comments: Used in live mode to compare scripts.
Command: TS<0D>
Message Response: -5<0D>
Example: Send Command: TS<0D>
Response: -5<0D>
SF Get/Set Active Script file
Description: This command will get the current script file or set the script to be used by the
show controller.
Comments: If there are multiple scripts on the CF card the user may select one to become
active.
Get command: SF<0D>
Message Response: (current file name) <0D>
Example: Send Command: SF<0D>
Response: sequences1.ami<0D>
Set command: "scriptname.ami"SF<0D>
Message Response: R<0D>