Alcorn Mcbride V16Pro - XX; NI; NE

Serial and Ethernet Control Page 161
Control
Example: Send Command: Sport1|"Hello World"SS<0D>
Response: R<0D>
XX Reboot
Description: This command will perform a hard reboot of the system.
Comments: The show controller will reload and run the selected script. The normal power
on response will apply
Command: XX<0D>
Message Response: K<0D>
Example: Send Command: XX<0D>
Response: K<0D> (after a rebooting only)
NI Get/Set NTP IP Address
Description: This command will get or set the NTP IP address needed to contact the
timeserver.
Comments: The default IP address is 068.216.79.113. Other examples are Boulder Colorado
US is 132.163.4.101 Europe is 213.251.169.205
Get command: NI<0D>
Message Response: (current NTP address)<0D>
Example: Send Command: NI<0D>
Response: 68.216.79.113<0D>
Set command: "NTP IP address"NI<0D>
Message Response: R<0D>
Example: Send Command: "68.216.79.113"NI <0D>
Response: R<0D>
NE Enable/Disable the NTP Function
Description: This command will enable or disable the NTP function and will get the current
status.
Comments: 0 = disable, 1 = enable
Get command: NE<0D>
Message Response: (current status)<0D>
Example: Send Command: NE<0D>
Response: 1<0D>
Set command: (0 or 1)NE<0D>