Alcorn Mcbride V16Pro - MS; TMS; JP

Serial and Ethernet Control Page 169
Control
Example: Send Command: ARX<0D>
Response: R<0D>
MS Get/Set Master Slave Message
Description: This command will get or set the Master Slave Message.
Comments: “1” represents force to slave, “2” represents force to master, and “0” represents
force to be stand alone (disabled).
Get command: MS<0D>
Message Response: (0|1|2)<0D>
Example: Send Command: MS <0D>
Response: 2<0D>
Set command: (0|1|2)MS <0D>
Message Response: R<0D>
Example: Send Command: 2MS <0D>
Response: R<0D>
TMS Get/Set Master Slave Timeout Period
Description: This command will get or set the Master Slave Timeout Period. Time delay
before assuming master is gone.
Comments: “nnn” represents the time in milliseconds.
Get command: TMS<0D>
Message Response: (nnn)<0D>
Example: Send Command: TMS <0D>
Response: 5000<0D>
Set command: (nnn)TMS <0D>
Message Response: R<0D>
Example: Send Command: 5000TMS <0D>
Response: R<0D>
JP Jump to Timecode Message.
Description: This command jumps a sequence to a specific point in time.
Comments: Does not change SMPTE synced sequences
Command: <SequenceName>|<timecode>JP<0D>
Message Response: R<0D>
Example: Send Command: TMS <0D>
Response: 5000<0D>