Example: Send Command: "sequences1.ami"SF<0D>
Response: R<0D>
NM Get/Set Device Name
Description: This command will get the current device name or set the name of the device.
Comments: This can be used to "Name" your V16Pro for reference when you're looking at
the device list in Live Mode.
Get command: NM<0D>
Message Response: (current device name) <0D>
Example: Send Command: NM<0D>
Response: deviceName<0D>
Set command: "deviceName"SF<0D>
Message Response: R<0D>
Example: Send Command: "Device1"SF<0D>
Response: R<0D>
FT Get Script Edit Date
Description: This command will get the ‘last edited’ date of the active script on the device,
or another non-active script on the device.
Comments: This can be useful to see when the script on the show controller was last
updated.
Get command: FT<0D>
Message Response: yyyy-mm-dd hh:mm:ss<0D>
Example: Send Command: FT<0D>
Response: 2009-02-13 23:31:30<0D>
Get command: "scriptname.ami"FT<0D>
Message Response: yyyy-mm-dd hh:mm:ss<0D>
Example: Send Command: "sequences1.ami"FT<0D>
Response: 2013-02-14 15:10:54<0D>
DH Enable/Disable the DHCP Function
Description: This command will enable or disable the DHCP function and will get the current
status.
Comments: x is 0 = disable, 1 = enable
p is A = port A, B = port B
To Next Page