WinScript Live Resources Page 24
5. Enter the number of "Inputs" and "Outputs" you will be controlling into the boxes.
The "StartingInput" and "StartingOutput" are typically 0, but may be a greater number if you're
only controlling a sub-section of the IO on a particular control module. For example, if you only
wanted to watch inputs 3-12 on a module that had 0-12 available.
The "InputPollFrequency" can be set to as little as 1 frame. If you have greater than nine devices that
are setup to poll inputs, you must decrease the polling to 2 frames or more.
The "OutputPollFrequency" is typically set to zero. This does not mean that the outputs will never be
polled. They will be polled on startup and after any command is send to change the output's status. (ie:
after an "On", "Off" or "Toggle" command). If you prefer more constant polling, a recommended value
would be 15 frames.
To Next Page
Loading...