System Configuration Interface
193
Enova Digital Media Switchers - Hardware Reference Manual
On-Screen Display
Image Adjustments
Video Settings - Display Settings
Video Mute Click the check box to mute the video
Video Freeze Click the check box to freeze the video
Test Pattern In the drop-down list, select Off, Color Bar, Gray Ramp, SMPTE Bar, HiLo Trak, Pluge, or X-Hatch
Blank Color In the drop-down list, select Black or Blue
Allow Display Sleep Click the check box to allow the display to go to sleep after the specified time in seconds in the "Display Sleep
Delay(s)" field
Display Sleep
Display(s)
Enter the delay in seconds that the display will remain awake after the video route has been disconnected or the
input signal is removed.
Note: While most monitors handle the sleep function well, some monitors continually attempt to wake up, resulting in
constant or intermittent screen blanking when no video is present. For the video output attached to the
problematic monitor, either uncheck the Allow Display Sleep option and set the Blank Color or set VIDOUT_SLEEP-
DISABLE and VIDOUT_BLANK-<color> (see page 228).
FIG. 107 On-Screen Display
Video Settings - On-Screen Display
Enable OSD Click check box to enable/disable
OSD Color In the drop-down list, select Black, Blue, White, or Yellow
OSD Position In the drop-down list, select Top Left, Top Right, Bottom Left, or Bottom Right
FIG. 108 Image Adjustments
Video Settings - Image Adjustments
Brightness Use the slider bar to adjust (range: 0 to 100)
Contrast Use the slider bar to adjust (range: 0 to 100)
To Next Page
Loading...
Need help?
General
