EasyManuals Logo

AMX Enova DGX 100 Series Hardware Reference Manual

AMX Enova DGX 100 Series
290 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #258 background imageLoading...
Page #258 background image
Appendix D - Telnet Communication with DGX CPU
258
Enova Digital Media Switchers - Hardware Reference Manual
Confirming Telnet Session is Enabled/Disabled
The Telnet session's status (enabled/disabled) may be checked through either NetLinx Studio or through a serial
connection to the DGX.
Via NetLinx Studio
1. Open NetLinx Studio and navigate to the OnLine Tree.
2. Right-click on the Enova Integrated Master (000000 device) and select TELNET Window/Launch TELNET Window via
NetLinx Studio. The terminal opens.
3. Type the following command string into the terminal:
SEND_COMMAND 5002:1:1, "'?ifconfig-1'"
4. Scroll through the output response (e.g., IFCONFIG-1,UP,S,ip=10.103.4.155,gw=10.103.4.1,
mask=255.255.255.0,hn=DGX_Telnet) and look for a setting of either UP (Telnet enabled) or DOWN (Telnet
disabled).
Via Serial Connection
1. Enter the DGX_SHELL terminal interface (see instructions on page 273).
2. Send the following DGX_SHELL command:
DGX_SHELL> set
3. Scroll through the command's response and look for the line:
mcpu_eth1_enabled=<ENABLE or DISABLE>.

Table of Contents

Other manuals for AMX Enova DGX 100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AMX Enova DGX 100 Series and is the answer not in the manual?

AMX Enova DGX 100 Series Specifications

General IconGeneral
BrandAMX
ModelEnova DGX 100 Series
CategorySwitch
LanguageEnglish

Related product manuals