TPDesign4 Project Files
25
PDesign4 Touch Panel Design Program
Project Properties dialog - Sensors tab
Use the options in the Sensors tab of the Project Properties dialog to view/edit light, motion and
battery charge level sensor information associated with the active panel file. The options in this tab
include:
Project Properties dialog - IR Emitters and Receivers tab
This tab is only present if the target panel selected for this project supports an IR emitter or an IR
receiver.
Use the options in this tab to view/edit port information associated with the active panel file for
AMX 38KHz IR emitting and receiving, AMX 455KHz IR emitting and receiving, and up to two
user-defined ports for IR emitting using custom IR files.
The options that are available in this tab depend on the IR capabilities of the target touch panel for
this project. For example, the Modero CV7 panel has an IR receiver, but does not have an IR
emitter. In this case, the only fields that are enabled in this tab would be the AMX IR Receivers
(38KHz and 455KHz) fields, where you could specify a channel port assignment for either 38KHz
or 455KHz IR reception.
The NXD/T-CV7 have AMX IR receivers, and the MVP-7500 and MVP-8400 have AMX and
User-defined IR emitters, as well as a cradle sensor.
The options in this tab include:
• Inactivity page Click the down arrow to select which page to flip to after the specified
period of inactivity (set on the touch panel).
• Feedback blink rate If you are using blinking button feedback in your project, use this field to
specify the blink frequency, in 1/10th-second increments (default = 5).
• Light Sensor: Use these fields to specify the Level and Channel port/code assignments for
the on-board light sensor.
• Motion Sensor: Use these fields to specify the Channel port/code assignments for the on-board
motion sensor.
• Battery Levels: Use these fields to specify the Level port/code assignments for the on-board
battery charger.
• Cradle Sensor
Button (MVP
panels only):
Use these fields to set the Channel port/code assignments for the Cradle Sen-
sor on MVP panels. The channel will be turned on when the panel is docked
(either in the tabletop docking station or in the wall cradle).
Note: The cradle sensor shares the same device number as the MVP panel.
• AMX IR Emitters
(MVPs only):
These options allow you to specify the IR Channel port (either 38KHz or
455KHZ) to be used for standard AMX IR emitting for MVP-7500 and MVP-
8400 panels.
• User IR Emitters
(MVPs only):
These options allow you to specify the IR Channel port (either 38KHz or
455KHZ) to be used for user-defined IR emitting for MVP-7500 and MVP-
8400 panels.
• AMX IR Receivers
(CV7s only) :
These options allow you to specify the IR Channel port (either 38KHz or
455KHZ) to be used for AMX IR receiving for NXD/T-CV7 panels.
The IR receivers and transmitters on G4 panels share the device address number of
the panel.
To Next Page
Loading...
Need help?
General
