Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Align engine/transmission in installed position. To do this,
tighten -10 - 222 A- spindles until transmission bracket -1- lies
on transmission mount -2-.
– Also place the -V.A.G 1383 A- under the transmission in the
area of the differential and raise until the transmission bracket
is parallel to the transmission mount.
Note
To prevent the threads in the transmission bracket from being
damaged, the transmission mount and bracket must be parallel
to one another.
– Install the transmission mount. Refer to
⇒ “2.9 Subframe Mount Assembly Overview”, page 72 .
Note
Install engine/transmission mountings stress-free. Refer to ⇒ En‐
gine Mechanical; Rep. Gr. 10 ; Description and Operation .
Caution
Do not remove -10 - 222 A- until all bolts for left assembly
mounting have been tightened to tightening specification.
– Install the bevel box bracket ⇒ page 113 .
– If equipped, install small cover plate -A- behind the bevel box
-arrow- ⇒ page 113 .
– Install the left and right drive axles. Refer to ⇒ Suspension,
Wheels, Steering; Rep. Gr. 40 ; Removal and Installation .
– Install the right drive axle heat shield ⇒ page 113 .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
110 Rep. Gr.34 - Controls, Housing
To Next Page
