– Apply a small amount of grease -G 000 450 02- to the trans‐
mission shift lever -1- pins -arrow-.
– Slide the shift cable onto the pin -arrow- and secure with lock
washer -3-.
Metal selector relay lever -2-
– Apply a small amount of grease -G 000 450 02- to the pin
-arrow- of selector relay lever -2-.
– Slide the selector cable onto the pin -arrow- and secure with
the lock washer -4-.
Plastic selector relay lever -2-
– Insert the selector cable in the control cable retainer.
Continued for all vehicles
– Adjust shift mechanism. Refer to
⇒ “2.8 Shift Mechanism, Adjusting”, page 69 .
– Install the air filter housing. Refer to ⇒ Fuel Injection and Ig‐
nition; Rep. Gr. 24 ; Removal and Installation .
– Connect battery. Heed the instructions for work to be per‐
formed following battery connection. Refer to ⇒ Electrical
Equipment; Rep. Gr. 27 ; Removal and Installation .
– Check transmission fluid level inside the manual transmission.
Refer to
⇒ “1.1 Manual Transmission, Checking Gear Oil Level”, page
47 .
– Axle oil level in bevel box, checking. Refer to
⇒ “1.2 Gear Oil in Bevel Box, Checking”, page 48 .
– Install the left and right noise insulation -arrows-.
– Install the noise insulation frame. Refer to ⇒ Body Exterior;
Rep. Gr. 50 ; Removal and Installation .
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Removal and Installation .
– Install the wheels. Refer to ⇒ Wheel and Tire Guide; Rep. Gr.
44 ; General Information .
Transmission Installation Tightening Specifications
Note
♦
The tightening specifications apply only to lightly greased,
oiled, phosphated, or black-finished nuts and bolts.
♦
Additional lubricant such as engine or transmission oil may be
used, but do not use graphite lubricant.
♦
Do not use degreased parts.
♦
Tolerance for torque specification ± 15%.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
112 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
