Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Install left adapter -T40093/3-2- and right adapter -
T40093/3-3- on -T40093/3- .
– Remove ground (GND) wire from left longmember.
– Remove left and right connecting bolt for front part of long‐
member.
– Install adapters on longmembers with bolts that were removed
earlier -arrow-.
Note
The left side of the vehicle is shown in the illustration.
– Insert square tube -T40091/1- in connector -T40091/3- and
supports -T40093/3- as shown in illustration.
– Slide connector -T40093/4- onto square tube.
– Slide supports -T40091/2- with slide -T40093/5- into both con‐
nectors -T40093/4- .
WARNING
Risk of an accident due to loose support bridge parts.
♦ Secure -T40091/2- with pins and splints from -T40093/4- .
♦ Secure connector and supports with locking screws.
– Install -10 - 222 A /11- on slide and engine lifting eye.
– Tension the engine/transmission assembly by tightening the
3 spindles evenly.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 115
To Next Page
Loading...
