Audi TT 2007 - Page 144

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
The Area Below the Grooved Ball Bearing Seat in the Transmis‐
sion Housing has been Changed -arrow-
Area Below the Bearing Seat Lower Spacer
Washer
Through transmis‐
sion build date 09 04
6
Not deeper. No
From transmission
build date 10 04 6
Slightly deeper. Yes
– Place a spacer washer (85 mm outer circumference) -1- on
grooved ball bearing -2-.
In the Case of Transmissions with Flattened Areas -A- on the
Grooved Ball Bearing for the Input Shaft and on Bearing Mount
-B-
• Do not place any spacer washers above and below the
grooved ball bearing.
• Flattened areas -A- on the grooved ball bearing and on bearing
mount -B- must align in the transmission housing.
– Mark the flattened areas with color.
– Place a marking on the upper area of the grooved ball bearing
and on the upper area of the transmission housing bearing
mount (⇒ next illustration).
– Heat the transmission housing using the hot air blower -V.A.G
1416- in the area of the bearing seat for the grooved ball bear‐
ing/input shaft to approximately 100 °C (212 °F) for approxi‐
mately 10 minutes.
Note
It is necessary to heat the transmission housing so that the
grooved ball bearing is not damaged when the housing is being
installed.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
138 Rep. Gr.34 - Controls, Housing