Audi TT 2007 - Page 143

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Fasten the bracket -30 - 211 A- for the input shaft to the clutch
housing.
Note
For the sake of illustration, clutch housing is depicted rotated
180°.
– Screw in bolt -A- far enough until input shaft rises slightly.
Note
♦ With some transmissions, there are flattened areas -A- on the
input shaft grooved ball bearing and on the bearing mount
-B-.
♦ Check the input shaft grooved ball bearing and the transmis‐
sion housing.
Input shaft grooved ball bearing and transmission housing
Without flattened areas on grooved ball bearing -A- and bearing
mount -B- ⇒ page 137
With flattened areas on grooved ball bearing -A- and bearing
mount -B- ⇒ page 138
From transmission build date 4.10.06 through approximately
1.21.08
One spacer washer is inserted above and below the input shaft
grooved ball bearing -6- ⇒ page 180 .
Upper spacer wash‐
er
Outer circumfer‐
ence
78.6 mm
Lower spacer wash‐
er
Outer circumfer‐
ence
85 mm
Measure the Shoulder above the Grooved Ball Bearing Mount.
Shoulder Above
Grooved Ball Bear‐
ing
Dimension “a” Upper Spacer
Washer
Through transmis‐
sion build date 09 04
6
10 mm No
From transmission
build date 10 04 6
10.7 mm Yes
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly 137