Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
♦
It is necessary to heat the transmission housing so that the
grooved ball bearing is not damaged when the housing is be‐
ing installed.
♦
Align the marking on the grooved ball bearing -A- with the
marking on the transmission housing -B- and mount the trans‐
mission housing.
♦
Apply sealing paste -AMV 188 200 03- evenly onto the sealing
surface of the clutch housing.
– Install transmission housing and tighten new bolts -A-, -B- and
-C- to tightening specification.
Allocation of bolts:
A - Bolt with permanent washer
B - Bolt without washer
C - Bolt with permanent washer
– Install circlip -1- for grooved ball bearing/input shaft.
– Remove -30-211A- for input shaft.
– If selector shaft lock sleeve has been removed, drive it in now
as far as stop on tool ⇒ page 155 .
– Turn transmission with opening for selector shaft in assembly
stand upward.
– Insert selector shaft -1- into lower mounting -2- and into shift
forks -3-.
Note
To improve clarity, the cap is removed.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly 149
To Next Page
Loading...
