Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Now press selector shaft -1- against lock sleeve -2- direction
of -arrow- and guide downward with shift finger -3- through
shift forks until stop.
• Shift cover -4- must stand parallel to bolting surface on trans‐
mission housing during this.
• Selector shaft must be able to be moved easily in selector
motion (up- and downward).
Note
If shift cover stands at an angle to bolting surface, selector shaft
is not inserted in lower bearing.
– Tighten the bolts -3- for the shift cover -4-.
– Install lock bolt -2-, lock elbow -arrow- must not be installed
when doing so.
– Install back-up light switch -F4- -1-.
– Install the flange shaft with spring, the thrust washer and ta‐
pered ring.
– Drive input shaft seal in flush.
– Install the clutch slave cylinder with release bearing. Refer to
⇒ “4.7 Slave Cylinder with Release Bearing”, page 39 .
– Shift through all gears.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
150 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
