Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Pressing Off Locking Collar and Synchronizer Hub for 1st and 2nd
Gears
– Remove circlip.
– Press off selector gear and locking collar/synchronizer hub all
together.
Pressing Off Inner Race for Tapered Roller Bearing
A - Separating device 22 to 115 mm , for example -Kukko 17/2-
Pressing on Tapered Roller Bearing Inner Race
Checking Inner Race for 1st gear, 2nd Gear and 3rd Gear for
Wear
– Press inner race onto taper of gear wheel and measure gap
dimension -a- using a feeler gauge.
Gap Dimension
-a -
Installed Dimension Wear Limit
1st, 2nd and 3rd
gear
0.75 to 1.25 mm 0.3 mm
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
3. Disassembly and Assembly 197
To Next Page
Loading...
