Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Pulling Out Tapered Roller Bearing Outer Race
A - Support , for example -Kukko 22/2-
B - Internal puller 56 to 70 mm , for example -Kukko 21/8-
Press the Outer Ring for the Tapered Roller Bearing into the
Clutch Housing
– Support clutch housing directly beneath bearing mount using
-40 - 20- .
Pulling off Inner Race for Tapered Roller Bearing
– Remove circlip.
– Before attaching extractor, place -VW 431- and -40 - 105- on
input shaft.
Pulling Off Synchronizer Hub/Operating Sleeve for 3rd and 4th
Gear with Gear Wheel for 4th Gear
– Before pulling off, remove circlip.
A - Extractor , for example -Kukko 18/2-
B - Separating device 22 to 115 mm , for example -Kukko 17/2-
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
196 Rep. Gr.35 - Gears, Shafts
To Next Page
Loading...
