Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Only Check the Position of the Adjustment Mechanism in the
Case of new SAC Pressure Plates
• Both edges -A- of the adjusting ring must be located between
both notches -B arrows-.
• If the adjusting ring takes on a different position with new pres‐
sure plates, pressure plate and clutch plate must not be in‐
stalled.
• With used clutches, the adjusting ring may take on a position
outside of the notches.
Clutch Plate Installation Location
• Marking Getriebeseite -arrow- (transmission side) faces to‐
ward transmission.
– Insert -3067- .
– Position the pressure plate on the alignment pins.
– To center the clutch plate, use the -T10097- .
Install the pressure plate as follows so that the pressure plate
does not distort during installation (causing shuddering during
acceleration):
– Install all 6 bolts evenly, by hand, until the bolt heads contact
the pressure plate.
– Tighten all 6 bolts clockwise, one after the other and in steps
of 90° (
1
/
4
turn) until the housing contacts the flywheel.
– Tighten all 6 bolts clockwise, one after the other to tightening
specification. Tightening specification -4- ⇒ page 25 .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
44 Rep. Gr.30 - Clutch
To Next Page
Loading...
