Audi TT 2007 - Page 72

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
13 - Control Cable Mounting Bracket
14 - Bolt
❑ 20 Nm
❑ Quantity 3
15 - Grommet
16 - Bushing
17 - Nut
❑ Only in vehicles with a 4-cylinder engine
18 - Selector Relay Lever
❑ Made of plastic
❑ Different versions; allocation, refer to the electronic parts catalog ETKA
❑ Installation location ⇒ page 67
❑ Remove the selector relay lever with catch from the transmission shift lever and attach ⇒ page 68
❑ Remove the selector relay lever with clip from the transmission shift lever and attach ⇒ page 69
19 - Slide Shoe
❑ Installation location ⇒ page 67
20 - Control Cable Retainer
❑ For the selector cable on the selector relay lever
❑ Allocation ⇒ page 62
❑ Disconnect from the selector cable ⇒ page 67
21 - Lock Elbow
❑ For adjustment of shift mechanism, refer to ⇒ “2.8 Shift Mechanism, Adjusting”, page 69
Allocation of Control Cable Retainers
The holes in the control cable retainers have various diameters.
Control Cable Retainer For: Dimension “a”
-1- Shift cable on transmission shift lever 8.5 mm
-2- Selector cable on selector relay lever 10 mm
Installing the Transmission Shift Lever
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
66 Rep. Gr.34 - Controls, Housing