Audi TT 2007 - Page 73

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– When positioning the transmission shift lever, make sure the
gap -arrow A- is placed over the missing selector shaft teeth
-arrow B-.
Installation Position of Transmission Shift Lever/Selector Relay
Lever
1 - Transmission shift lever
2 - Clip or catch (depending on the version)
3 - The selector relay lever engages in the transmission shift lever
slide rail via the slide shoe -arrow B-.
– Lubricate the slide rail and slide shoe -arrow- with grease -G
000 450 02- .
Disconnect the Control Cable Retainer from the Shift Cable and
Selector Cable
– Pull the securing mechanism forward to the stop -arrow 1- and
then lock to the left -arrow 2-.
– Remove control cable -B- from control cable retainer -A-.
Remove the Shift Cable from the Transmission Shift Lever and
Attach
Removal
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 67