Avaya MCC1 - New or Upgraded G3 Si Only; New Simplex and Upgraded G3 R Only

G3V4vs/R5vs/R6vs to Avaya Communication Manager
Task List: DEFINITY vs to Avaya Communication Manager
SI Installation and Upgrades 161
June 2004
2 Type set time and press Enter.
Ensure that the system date and time are set correctly.
3 Use one of these installation methods:
— Direct connection between the switch and RFA
— No connection between the switch and RFA
4 Type save translation and press Enter.
After the translations have been copied (about 10 minutes), the system returns an error code,
which must be a zero; otherwise, the translations are not copied.
5 Type reset system 4 and press Enter.
Wait until the system has completely reset before continuing.
6 Type change cabinet 1 and press Enter.
In the
Carrier Type column change the “B” carrier to processor and submit the form.
7 Type change system-parameters duplication and press Enter.
Set the
Enable Operation of SPE Duplication field to y and submit the form.
8 Type save translation and press Enter.
After the translations have been copied (about 10 minutes), the system returns an error code,
which must be a zero; otherwise, the translations are not copied.
9 Type reset system 3 preserve-license (or reset system 3 no-preserve-license, since the
License File has been saved in translations) and press Enter.
New simplex and upgraded G3r only
1 Type save translation and press Enter.
After the translations have been copied (about 10 minutes), the system returns an error code,
which must be a zero; otherwise, the translations are not copied.
2 Type reset system 3 and press Enter.
Wait until the system has completely reset before continuing.
3 If the system has IP endpoints registered, unplug the Ethernet cable from the TN799 (C-LAN)
circuit pack.
This disconnects (unregisters) all IP endpoints.
4 Type set time and press Enter.
Ensure that the system date and time are set correctly.
5 Use one of these installation methods:
— Direct connection between the switch and RFA
— No connection between the switch and RFA
New or upgraded G3si only
1 Retrieve the RFA License File with both serial numbers from the RFA Application.
2 If the system has IP endpoints registered, unplug the Ethernet cable from the TN799 (C-LAN)
circuit pack.
This disconnects (unregisters) all IP endpoints.