G3iV4 to Avaya Communication Manager
Task List: G3iV4 to Avaya Communication Manager
68 SI Installation and Upgrades
June 2004
Make the Blowback Tape
To upload the translations remotely, contact the CSA. If you choose to make a blowback tape, follow this
procedure:
NOTE:
There must always be 2 system tapes on site with the DEFINITY system. Do not send the
system or backup tape to the CSA.
1 Get a blank R1V3 tape from the regional CSA. This will be the blowback tape.
2 Remove the backup tape, install the blowback tape, and wait for the tape to retension.
NOTE:
The off-site CSA translation upgrade does not preserve the contents of recorded
announcements on TN750/B or earlier circuit packs. Therefore, if a TN750/B or earlier
circuit pack resides in the stack of single-carrier cabinets which is dismantled during the
upgrade, any announcements stored on the circuit pack must be rerecorded.
3 Enter save translation. Press Return.
4 Remove the blowback tape and label it with IL information (customer name and customer
contact).
5 Reinstall the system tape.
6 Use next-day delivery to mail the blowback tape to the CSA for use in making the translation
memory cards for the upgrade.
Task List: G3iV4 to Avaya Communication Manager
Use this task list when you are upgrading a DEFINITY G3iV4 PPN to Avaya Communication Manager.
Ensure that these tasks are complete before the upgrade visit:
1 Verify the required hardware [G3V4 to from R5/R6/R7/R8si]
2 Provide the required tools [from G3V4]
3 Go to the RFA website [from G3V4]
4 Pre-upgrade administration [from G3V4]
Perform these tasks during the upgrade visit:
5 Check existing software load [from G3V4] to identify any software patches.
6 Disable scheduled maintenance and alarm origination [from G3V4]
7 Verify system status [from G3V4] Record any customer-placed busy-outs.
8 Record all links and remove only ISDN interface links [from G3V4]
To Next Page
Loading...
