Release 9si/10si/Communication Manager 1.x to Communication Manager 2.1
Task list: R9si/10si/Communication Manager 1.x to Communication Manager 2.1
48 SI Installation and Upgrades
June 2004
Check link status
Return to Task List
This optional step is to make sure the links are in service before and after the upgrade.
1 Type display communication-interface links and press Enter. Write down all enabled links.
2 Type status link number and press Enter for each enabled link.
3 Write down which links are enabled and in service.
NOTE:
If any links are enabled and out of service, resolve the problem before continuing the
upgrade.
4 Type list signaling group and press Return.
Note the signaling groups listed by number.
5 For each of the signaling groups listed, type status signaling group <number> and press
Return.
6 If any of the links are not up, take the necessary corrective action to restore the link before
continuing with the upgrade.
Return to Task List
Save translations
Return to Task List
NOTE:
Duplicated translations must match exactly or the command fails.
High and Critical Reliability
1 Execute status system 1 before you save translations.
2 Verify that conditions are normal (this can take as long as 5 to 10 minutes). If the system refuses
to go into a normal condition, refer to the maintenance procedures; if that fails, escalate the
problem.
All
1 Ensure that the translation card (ATA) is in the TN2401 (Netcon/Pkt Intf) circuit pack’s card slot.
2 Type save translation and press Return to write all translations from memory to the translation
flashcard (about 10 minutes).
The screen goes blank. This is normal.
NOTE:
Do not press any keyboard key until after the system displays the status (success or
failure) message. If you press Return again, you will not see the status message.
To Next Page
Loading...
