Install Fiber Optic Cable Pass-Thru Kit for SCC1 (Single-Carrier) Cabinets
Administering Fiber Optic Cables
210 SI Installation and Upgrades
June 2004
Administering Fiber Optic Cables
NOTE:
You administer Fiber Optic Cables only on an Avaya Media Gateway or in a Multicarrier
Cabinet (MCC1).
When a fiber optic cable is properly labeled, it is easy to trace the desired circuit by looking at the labels
on the cross-connect, the cable itself, and the individual fibers in the cable.
Refer to
• Fiber Link Administration Form
• Administration commands
• PN reliability configurations
• Task List: Administration Details
Fiber Link Administration Form
This form administers fiber links, each of which is identified by a fiber number.
Port networks (PNs) are connected via direct fiber link connections or through a center stage switch
(CSS) to provide the interconnection of port networks required for voice/data information transfer. The
CSS is composed of "switch nodes" that can be interconnected in one or two levels to provide Port
Network Connectivity (PNC). The CSS provides circuit-switched connectivity for voice and data
communications as well as packet-switched connectivity. Fiber link administration permits an
administration of translation data associated with a switch connection (such as optical fiber, metallic
cable, or DS1CONV circuit packs and DS1 facility links between two endpoints). The two fiber
endpoints can be:
• An expansion interface (EI) circuit pack
• A switch node interface (SNI) circuit pack
NOTE:
Only one administrative terminal can administer fiber links at a time; others can display
fiber link information.
Administration commands
Use the following commands to administer the Fiber Link Administration form.
Action Object Qualifier
add fiber-link link number or [’next’]
change fiber-link link number
display fiber-link link number
list fiber-link link number
remove fiber-link link number
To Next Page
Loading...
