Install Additional Hardware
Add Packet Bus Support
588 SI Installation and Upgrades
June 2004
Save Translations (CallVisor ASAI)
Return to Task List
1 If the system is high or critical reliability, type status system 1 and press Enter to verify that the
system is in the
active/standby mode.
2 Type save translation and press Enter. This instructs the system to take all translation
information in memory and write it to the translation cards.
3 Update backup translation cards, if required.
Add Packet Bus Support
Return to Task List
You may need to add packet bus support when adding ISDN - BRI or CallVisor ASAI port circuit packs.
NOTE:
Installing TN570D expansion interface circuit packs as part of adding packet bus support
requires a service interruption. Give the customer advance notice of the scheduled
addition.
Task List: Add Packet Bus Support
• Disable Alarm Origination (Packet Bus Support) on page 589
• Save Translations (Packet Bus Support) on page 589
• Power Down Cabinet (Packet Bus Support) on page 589
• Install Circuit Packs (Packet Bus Support) on page 589
• Power Up System (Packet Bus Support) on page 590
• Test the Packet Bus and C-LAN Circuit Pack (Packet Bus Support) on page 592
• Resolve Alarms (Packet Bus Support) on page 592
• Enable Scheduled Maintenance and Alarm Notification (Packet Bus Support) on page 592
• Save Translations (Packet Bus Support) on page 593
If installing TN570D Expansion Interface circuit packs as part of adding packet bus support, then service
is interrupted. Notify the customer in advance as to when the addition will be carried out.
If not installing TN570D circuit packs, then service is not interrupted and you can skip to Install Circuit
Packs (Packet Bus Support) on page 589
To Next Page
Loading...
