G3iV4 to Avaya Communication Manager
Task List: G3iV4 to Avaya Communication Manager
SI Installation and Upgrades 75
June 2004
Check existing software load [from G3V4]
Return to Task List
1 Type list configuration software-version and press Enter.
2 Check the UPDATE FILE column and make a record of any patches that have been applied.
If the system has to be restored to the old software, you will need to download the patches onto
the system.
Return to Task List
Verify system status [from G3V4]
Return to Task List
1 Verify that system status is normal.
Execute
status system 1 (If status is not normal, take the needed corrective actions.)
2 Verify that the system is alarm-free.
Execute
display alarms (If the system is not alarm-free, take the needed corrective actions.)
3 Identify and record customer-placed busy-outs.
Execute
display errors (Examine the error log and record the error 18s that identify the busy-outs
placed by the customer.)
NOTE:
You will restore the customer-placed busy-outs after you have upgraded the system.
4 For a system that has existing BX.25 links that are being retained after the upgrade: identify and
record them.
Execute
display communication-interface links
5 Execute the following commands and verify that the information is correct:
list station
list trunk-group
list hunt-group
list data-module
For upgrades from systems later than G1, list ars analysis
For a system with Expert Agent later than G3V3,
list agent
If any command does not complete successfully, escalate the problem immediately.
Return to Task List
To Next Page
Loading...
