Avaya MCC1 - Administer No-License;Emergency Numbers [From G3 V4]; Verify the Upgrade [From G3 V4]

G3iV4 to Avaya Communication Manager
Task List: G3iV4 to Avaya Communication Manager
SI Installation and Upgrades 85
June 2004
Administer No-License/Emergency Numbers
[from G3V4]
Return to Task List
If the system enters a No-License mode, the switch only processes emergency calls. Use this procedure to
adminster the emergency numbers for No-License mode situations.
1 At the SAT, type change system-parameters features and press Enter.
The Feature-Related System Parameters screen displays.
2 In the Emergency Numbers - Internal field (optional) type a valid extension.
NOTE:
This field is intended for campus environments where there is an internal emergency
number that people are directed to use instead of 911. Calls to other extensions will not go
through. This number cannot be a hunt group or ACD number.
3 In the Emergency Number - External field (required) type a 21-digit, dialpad-valid
character string that can include trunk access codes. The default for this field is 911.
4 In the No-License Incoming Call Number field (optional) type a valid extension.
NOTE:
All calls are not rerouted to this number; only calls to this number get through. This
number cannot be a hunt group or ACD number.
5 Press Enter to save the changes.
Verify the upgrade [from G3V4]
Return to Task List
1 Execute status system 1 and verify that the system is in a normal state.
2 Type display alarms and press Enter.
If the system is not alarm-free, take the needed corrective actions.
3 Type list configuration software-version (simplex) or list configuration software-version long
(duplex) and press Enter. Check the
Memory Resident field to verify that it shows the correct
software load.
4 Type display communication-interface links and press Enter.
Status each of the links.
NOTE:
ISDN-PRI D-channel links no longer appear on this screen. (For release 7 and later,
ISDN-PRI resides on the network packet circuit pack.) For release 7 and later, the only
way to determine if an ISDN-PRI D-Channel is up is to use the status signaling group
command.