G3iV4 to Avaya Communication Manager
Task List: G3iV4 to Avaya Communication Manager
SI Installation and Upgrades 77
June 2004
7 For each processor channel where the Application field is ISDN, record the information in all
fields.
If you must back out of the upgrade, you will need this information.
8 Type change communication-interface processor-channels and press Enter.
9 For each processor channel where the Application field is ISDN, clear the information from
all fields and press Enter.
10 Type change communication-interface links and press Enter.
11 For each PI extension where the Prot field is ISDN make these entries:
12 Press Enter.
13 For each PI extension where the Application field is ISDN:
a Type display data-module [PI EXT] and press Enter. Record the information in each
field.
If you must back out of the upgrade, you will need this information.
b Type remove data-module [PI EXT] and press Enter.
Return to Task List
Save translation [from G3V4]
Return to Task List
NOTE:
To save translations on duplicated systems, the systems must be in sync or the command
will fail.
For High and Critical Reliability only, execute
status system 1 before you save translations.
Verify that conditions are normal (this can take as long as 5 to 10 minutes). If the system refuses to go
into a normal condition, refer to the maintenance procedures; if that fails, escalate the problem.
1 Type save translation and press Enter.
This takes about 10 minutes.
NOTE:
Do not press any keyboard key until after the terminal displays the success message. For
example, if you press Enter more than once after typing the command, the second Enter
erases the screen and you never see the success message.
Field Value
Est Conn n
Prot bx25
DTE/DCE dte
Identification [blank]
To Next Page
Loading...
