Avaya MCC1 - Administer No-License;Emergency Numbers [From G3 V4 Vs;R5 Vs;R6 Vs]; Direct Connection between the Switch and RFA; No Connection between the Switch and RFA

G3V4vs/R5vs/R6vs to Avaya Communication Manager
Task List: DEFINITY vs to Avaya Communication Manager
162 SI Installation and Upgrades
June 2004
3 Type set time and press Enter.
Ensure that the system date and time are set correctly.
4 For duplicated systems only type status system all and press Enter.
Ensure that the standby SPE is not in the maintenance state. If it is, wait for the maintenance state
to finish.
5 Use one of these installation methods:
— Direct connection between the switch and RFA
— No connection between the switch and RFA
Direct connection between the switch and RFA
a Go to the RFA website, and, following the instructions in the “Deliver to G3r/G3si/G3csi”
chapter of the RFA Job Aid, deliver the License File.
NOTE:
This procedure sends the License File to the switch and installs it.
b If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
No connection between the switch and RFA
a Go to the RFA website, and, following the instructions in the “Deliver to G3r/G3si/G3csi”
chapter of the RFA Job Aid, deliver the License File to your laptop/PC.
b Open the License Installation Tool (LIT) application at your laptop/PC.
c Use the LIT instructions to add a switch connection profile to the tool.
d Use the LIT instructions to install the License File on the switch.
e If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
Administer No-License/Emergency Numbers
[from G3V4vs/R5vs/R6vs]
Return to Task List
If the system enters a No-License mode, the switch only processes emergency calls. Use this procedure to
adminster the emergency numbers for No-License mode situations.
1 At the SAT, type change system-parameters features and press Enter.
The Feature-Related System Parameters screen displays.
2 In the Emergency Numbers - Internal field (optional) type a valid extension.
NOTE:
This field is intended for campus environments where there is an internal emergency
number that people are directed to use instead of 911. Calls to other extensions will not go
through. This number cannot be a hunt group or ACD number.