Avaya PARTNER Advanced Communications System - Page 38

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Installing the Control Unit
2-6
5. Remove the clear plastic protectors from the
connectors on the right side of the wall-
mounted PARTNER ACS processor module
and the module to be added by grasping the
tabs on the ends of the protector and lifting
(see Figure 2-3).
Figure 2-3. Removing the Plastic
Protector
6. Slide the second module onto the PARTNER
ACS processor module, making sure the
mounting tracks interlock (see Figure 2-4).
Figure 2-4. Module Mounting Tracks
7. Attach the 2-slot carrier to the top right side of
the two modules (see Figure 2-5), properly
engaging the connectors on the modules to the
carrier.
Figure 2-5. Attaching the 2-Slot
Carrier
Tab
Tab
Mounting
Tracks
PARTNER
MODULE
206