Avaya PARTNER Advanced Communications System - Page 382

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Replacing Modules
10-16
Figure 10-12. Removing the Module
7. If you are replacing a module with one of a different type, make sure that all 400 (or 200)
modules are installed to the right of all 012E, 308EC, or 206 modules, and that the processor
module remains in the center slot. If you have a T1 module or a 1600 DSL module, it must be
in the first slot on the left of the carrier.
8. To insert the replacement, once the module is properly seated, firmly push the center of the
module until the connectors on the module lock into place, and the module is attached to the
rear of the carrier. For proper engagement of the connectors, the module must be inserted
straight into the carrier (see Figure 10-13). A slight click indicates the connectors are engaged.
Figure 10-13. Proper Insertion of the Module
PARTNER ACS Release 5.0 and later supports Endeavor telephones when an
Endeavor 362EC module is installed in the carrier. Install the Endeavor 362EC
module(s) to the right of the T1 module or 1600 DSL module, if one is installed, and to
the left of any 400 and 200 module.
PFT
PFT
E
X
T
E
N
S
I
O
N
S
L
I
N
E
S
MODULE
206
P
A
R
T
N
E
R
30
0
0
Carrier Shelf
YES
Carrier Shelf
NO