Avaya PARTNER Advanced Communications System - Page 46

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Installing the Control Unit
2-14
4. Press the power cord firmly into the power jack on
the carrier or the stand-alone processor module
until the cord locks into place (see Figure 2-16).
5. Plug the other end of the power cord into a
properly grounded three-prong wall outlet that is
not controlled by a switch.
6. If you have a 5-slot carrier, move the On/Off
switch to the On (“—”) position.
CAUTION:
The power cord should hang straight down from
the connector for the entire length of the module
or carrier. Do not install the power cord at an
angle to the case or with a loop in it.
7. If this is the initial installation for a Release 3.0
system, follow these additional steps:
a. Check the LEDs to make sure that the
processor is on steady green for at least
15 seconds.
b. Press
f00ss#
989
at extension 10 or 11.
c. Press
25327.
The system resets. You may proceed with
the rest of the installation upon
completion of the reset (about 20
seconds).
Figure 2-16. Attaching the Power
Cord
Stand-Alon
e
2-Slot
5-Slot