© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 107 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
14 Configuring - Modules Tab
Use the Modules tab to add, or remove monitors.
14.1 All View
The Modules tab only has two views; All and SAM.
Normally you will use the ‘All’ view.
14.1.1 Slot, Type, Description, Notes
Slot: The position of the monitor in the rack. Slot 1 is
the RCM and is not shown in the grid. Slot 2 is
normally the SAM.
Type: The installed Module Type
(UMM or TMM)
Description: Provides a general description for the
card. This field is shown in the Maintenance software
screen (see Figure 14-3), and on the touch panel (if
used).
Notes: Are used to help track changes, or store
comments for others who may access the
configuration later. The notes are also visible from the
Maintenance software (hardware info screen).
If the rack is an eight-slot rack, slots 9 through 16
must be configured as empty.
Figure 14-1) Modules Tab
Figure 14-2) Modules Tab – Views
Figure 14-3) Module description is shown here
14.2 SAM View
The SAM view shows all SAM properties. However, it is easier to edit the SAM properties by selecting
the SAM (in the grid) and opening the properties panel.
SAM properties include connection parameters for Modbus, CMS, Remote Access, and NTP Time
synchronization. Please see the following sections:
• Section 21 Configuring – Modbus
• Section 13 Configuring - CMS Data Collection
• Section 11.2 Remote Connection (Ethernet)
• Section 9.7 Rack Time Synchronization
Figure14-4) SAM, Properties panel
To Next Page
Loading...