Page 74 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
10.3.7 Hard to Find (Hidden) Properties
A few channels and measurements have configuration properties that are not shown in the
spreadsheet view. These properties can only be found in the properties panel. An example is the
Ramp Angle for a Differential Expansion channel.
If you are not familiar with the channel type you are configuring, you will need to check the properties
pane to ensure that all settings have been configured.
Figure10-9) Opening the Properties List
To Next Page
Loading...