BRUEL & KJAER VIBROCONTROL 8000 - 25.4.2 Group Name (Asset Level 1); 25.4.3 Polarity; 25.5 Simulator Enable (SAM)

© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 185 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
25.4.2 Group Name (Asset Level 1)
The Group Name (Asset Level 1) defines the group of channels that will be controlled by the Discrete
Input. Typically, each group is a different machine train.
Figure 25-3) Discrete Input channel configuration (Contacts view)
25.4.3 Polarity
Contact polarity is defined here.
• Logic Low: active when the input contact is closed, inactive when opened.
• Logic High: active when the input contact is open, inactive when closed.
25.5 Simulator Enable (SAM)
For demonstration purpose only (sales persons etc.)
This option enables the demonstration mode for the front panel display. This mode affects the display
only.