© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 33 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
4 Engineering - Channel Layout
There are certain rules that you should be aware of when planning the channel layout in the VC-8000
rack. These are explained below.
4.1 Phase Trigger Channels
The VC-8000 rack allows for six Phase Trigger channels maximum (16P rack). Phase Trigger
channels can only be selected in channel 4 of a UMM installed in slots 4-9.
Figure 4-1) Phase Trigger channels selection
4.2 Orbit (XY) Pairs
If your rack will be providing CMS data (like orbit, or shaft centerline), all XY pairs need to be in
channels 1 & 2 (or channels 3 & 4) of the same UMM.
To Next Page
Loading...