BRUEL & KJAER VIBROCONTROL 8000 - 23.10 Hardware Information

Page 162 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
23.10 Hardware Information
Hardware and licensing can be viewed using the VC-8000 Maintenance software.
Figure 23-2) VC-8000 Hardware and Licensing Information
The following table describes information available.
Label Description
Slot
The rack slot number the module is installed in.
Module
The module type
Sales Order
The sales order the module was purchased under.
Order Options
Option dash numbers
Serial Number
The module serial number.
Hardware Version
The hardware version and revision numbers.
Modifications
Part number for modifications applied. (optional)
Supported Features
Lists special features or plug-ins purchased with
the module.
Modbus TCP
Supports Modbus over Ethernet
Serial
Modbus
Supports Modbus over Serial Networks
CMS
Supports data output to SETPOINT CMS
SD
Supports storing dynamic data to the SD
card
HD32
Includes a 32 GB solid state drive
HD256
Includes a 256 GB solid state drive
Standard
Display
Supports the standard display
Ultra Display
Supports the ultra-bright backlight display
TMM and UMM supported features:
CMS
Supports data output to SETPOINT CMS
Firmware Version
The firmware revision
Last Configuration
The date the current configuration was downloaded
Table 23-5) Hardware Information