BRUEL & KJAER VIBROCONTROL 8000 - 23.3.1 RCM LED Indicators; 23.3.2 SAM LED Indicators

© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 153 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
23.3.1 RCM LED Indicators
The RCM has three LEDs labeled OK, P1, and P2. The table below provides a description of each
LED condition and recommended actions.
LED Condition Description Action
P1
On (Green)
Power 1 is connected and is between 18 and
36 Vdc.
No action required.
Off
Power 1 is not connected or is outside the
specified range.
Verify the external supplies are
powered.
Verify that wiring is not reversed.
Verify that the supply voltage is within
the specified range.
P2
On (Green)
Power 2 is connected and is between 18 and
36 Vdc.
No action required.
Off
Power 2 is not connected or is outside the
specified range.
Verify the external supplies are
powered.
Verify that wiring is not reversed.
Verify that the supply voltage is within
the specified range.
Ok
On (Green)
The rack is functioning normally, and the OK
relay is inactive.
No action required.
Off
• Transducer fault (Not Ok)
• Module inserted (rebooting)
• Module hardware failure
• SAM removed from rack
Check the event list.
Find (and repair) the faulted sensor.
If it is a module error, then replace the
module.
Table 23-1) RCM LED Indicators
23.3.2 SAM LED Indicators
The table below describes the SAM LEDs and their functions:
LED
Condition
Description
Action
OK
On (Green)
SAM is operating normally
Off
SAM is faulty
Verify the SAM is fully seated in the
slot (see section 23.1).
If powered, and seated, SAM is
faulty, replace.
Orange
(Steady)
CMS is enabled but not functioning
correctly
Check SETPOINT PI/XC Adapter
(software).
Verify network connections.
SD is enabled but not functioning
correctly.
Install (or replace) SD card.
Orange (Brief
blink)
Writing to SD card.
TM
On (Green)
Trip Multiply mode enabled
Note: Trip multiply can be enabled via
Modbus, or Discrete Contacts.
Off
Trip Multiply mode disabled
Display
OK
On (Green)
Display module connected
Off
Display module not connected or not
installed.
Verify the cable is properly installed
(see 12.4.2)
Table 23-2) SAM LED Indicators