BRUEL & KJAER VIBROCONTROL 8000 - 12.5 Connecting a Digital Multimeter; 12.5.1 Touch Screen Display Buffered Output Connectors (BNC); 12.5.2 UMM Buffered Output Connector (RJ-45)

© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 95 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
12.5 Connecting a Digital Multimeter
12.5.1 Touch Screen Display Buffered Output Connectors (BNC)
Each touch screen display has 3 BNC connectors that provide selectable access to any of the
channels in the rack.
Step 1 Step 2 Step 3
Step 4
Step 5
Table 12-7 Connecting to the BNC connectors on the touch screen display
12.5.2 UMM Buffered Output Connector (RJ-45)
Each UMM has an RJ-45 connector that provides access to the four buffered output signals using
cable 100431-AA and a BNC adapter (Pomona 1269).
Figure 12-15) Connecting to the UMM buffered output connector